DSS chip tube nozzle holder

Post here on Ortofon and Fonofilm Industri A/S cutters, amplifiers, and processors.

DSS chip tube nozzle holder

Postby Andrew » 08 Feb 2017, 23:20

This photo was taken in 1981 at Sunshine Sounds Enterprises, where Gary Ham was cutting with an Ortofon system on their LS-76.

DSS_Nozzle_holder.jpg (167.22 KiB) Viewed 425 times

The chip tube nozzle holder appears to connect to the bottom of the quick-disconnect block of the yoke. There are no screw holes on the bottom of that, but there is one screw hole on the bottom of the adapter block, which is attached to the cutter and which allows it to mate with the quick-disconnect block. So, perhaps it's attached to the adapter block, itself. Research is on-going. (;

User avatar
Site Admin
Posts: 82
Joined: 03 Apr 2013, 03:13

Return to Ortofon

Who is online

Users browsing this forum: No registered users and 1 guest