DSS chip tube nozzle holder

Post here on Ortofon and Fonofilm Industri A/S cutters, amplifiers, and processors.

DSS chip tube nozzle holder

Postby Fonotec » 08 Feb 2017, 23:20

This photo was taken in 1981 at Sunshine Sounds Enterprises, where Gary Ham was cutting with an Ortofon system on their LS-76.

DSS_Nozzle_holder.jpg
DSS_Nozzle_holder.jpg (167.22 KiB) Viewed 739 times


This moving chip tube nozzle holder appears to connect to the bottom of the quick-disconnect block of the yoke. That keeps the nozzle always aimed at the stylus.
User avatar
Fonotec
Site Admin
 
Posts: 84
Joined: 03 Apr 2013, 03:13

Re: DSS chip tube nozzle holder

Postby Fonotec » 25 Feb 2019, 01:02

Normally, the lathe chip tube nozzle is vertically stationary, although the entire chip tube moves laterally with the carriage.. This image from a YouTube video shows that the nozzle is always right above the lacquer surface, and the cutting head lowers and rises without moving the nozzle. The power for the stylus heater is disconnected via a microswitch until the cutting head drops, and is again disconnected as soon as it rises off of the disk.

Ortofon_stationary_nozzle.jpg
Ortofon_stationary_nozzle.jpg (32.93 KiB) Viewed 302 times
User avatar
Fonotec
Site Admin
 
Posts: 84
Joined: 03 Apr 2013, 03:13

Re: DSS chip tube nozzle holder

Postby Fonotec » 02 Mar 2019, 02:57

...and here:

DSS 661.jpg
DSS 661.jpg (46.79 KiB) Viewed 293 times
User avatar
Fonotec
Site Admin
 
Posts: 84
Joined: 03 Apr 2013, 03:13


Return to Ortofon

Who is online

Users browsing this forum: No registered users and 0 guests

cron